How To Make Your Own Stun Gun At Home?

In today’s world personal safety is imperative.includes, disposable camera, screwdriver, paper clip,
Everyone lives on the brim of life not knowing what isneedle-nosed pliers and electric tape.
to be expected at the next instant. It is always wiser- With the help of the screwdriver, dismantle the plastic
to be safe than sorry. Men and women get attackedcasing from the front of the camera. It normally pops
by mobsters and thieves every other night in isolatedoff easily.
street corners and they are rendered helpless most of- Carefully separate the flashbulb out of the camera.
the time. More so than men, it is the women who areMake sure that the circuit board, the capacitor and any
more prone to such crimes. Crimes against womenother wiring is left untouched and unhampered.
not only include petty thefts but also rape and assault.- After you have separated the flash bulb off the
Women all around the world, especially the youngercamera, locate the two terminals of the capacitor that
ones, are subjected to such unwanted andprotrude on the either side of the place where the
unscrupulous acts.flash bulb was previously fitted. Bridge these terminals
On the grounds of personal safety, there exist simpleto drain out all the charge left. For this you can use the
techniques of self-defense to protect oneself withouttip of a flat tipped screwdriver touching both the
outside help. You cannot always rely on the police toterminals at the same time.
appear out of nowhere when you are trapped in a- Take the paper clip in your hands and stretch it out
risky situation. One such self defense technique andinto a straight piece of wire. Using the pliers cut the
the most effective one is the use of stun guns. A stunpaper clip wire into two, at the center.
gun is a weapon that immobilizes the attacker by the- Bend the ends of the straightened paper clip wires
passage of high voltage. However, the amperage isinto a small hook and wire those hooks to the
minimal such that no permanent damage is caused.terminals of the capacitor. With the pliers, carefully
They have become quite effective, discreet and safeclose and lock the hooks into loops. This ensures that
to use self-defense weapons for the common man.each wire is firmly fastened to either terminals of the
Stun guns are normally aimed at the muscular part ofcapacitor.
the body like the buttocks, thigh, or shoulder and is to- Now reattach the camera casing in the front such
be pressed against it for a few seconds to getthat the two wires protrude from the seam in the
maximum result.casing. The distance between the wires is ideally
Normal stun guns available in the market can costexpected to be an inch.
from $50 to $100 which is a huge amount. We could- Tape the case firmly back in place on to the camera
consider buying it anyways, if we did not have anwhilst you take care that the two wires do not come
alternative. Although the good news is, stun guns canin contact with each other.
be made at home by you and it would only cost up to- Press the flash button to charge the stun gun. To
$5. So why not learn how to make a stun gun on yourpass on the charge on to a test subject simply touch
own which is both competent and economical.both the exposed wires to it.
Following are the steps to make your own homemadeThus it is ready, your own self-defense home made
stun gun:stun gun at minimal expense.
- The things needed to build your own stun gun